Suspended No Lacp Pdus. 请问光口显示suspended(no LACP PDUs)是物理端口坏了吗？ Cisco Community However, the reason should be the same as why it does not receive Protocol Data Units (PDUs) from the peer Also try the following no lacp graceful-convergence - allows for a longer wait period for lacp port initialization int port x no lacp suspend-individual - this helps prevent loops through bad switch config - when disabled the port is prevented from suspending if it doesn't receive a correct lacp packet- so use with caution!
LACP vs PAGP How They Differ for Network Redundancy from www.gezhiphotonics.com
By default, LACP sets a port to the suspended state if it does not receive an LACP PDU from the peer Verify LACP Suspended interface sh port-channel summary interface port-channel 1 Flags: D - Down P - Up in port-channel (members) I - Individual H - Hot-standby (LACP only) s - Suspended r - Module-removed b - BFD Session Wait S - Switched R - Routed U - Up (port-channel) p - Up in delay-lacp mode (member) M - Not in use.
LACP vs PAGP How They Differ for Network Redundancy
1019 Po1019(SD) Eth LACP Eth1/19(I)----> Indicates No PDUs are being received 1019 Po1019(SD) Eth LACP Eth1/19(I)----> Indicates No PDUs are being received lacp suspend-individual is a default configuration on Cisco Nexus 9000 series switches
Surge Protected PDU IEC C13 And UK 13Amp Sockets Vertical 0U DCDI. When I checked on the switch, I found that the port-channel groups (we have 2) both showed that one interface was up and participating in LACP, and that the other connection in the group showed "suspended - No LACP PDUs" lacp suspend-individual is a default configuration on Cisco Nexus 9000 series switches
Basic Industrial PDU 2 Way IEC C19 and 4 Way IEC C13 with L630 P Sockt. 1019 Po1019(SD) Eth LACP Eth1/19(I)----> Indicates No PDUs are being received Verify LACP Suspended interface sh port-channel summary interface port-channel 1 Flags: D - Down P - Up in port-channel (members) I - Individual H - Hot-standby (LACP only) s - Suspended r - Module-removed b - BFD Session Wait S - Switched R - Routed U - Up (port-channel) p - Up in delay-lacp mode (member) M - Not in use.